Having your driveway sealed will not only make it look good. It could also protect it against some elements. It is an investment that is worth it.
If you are planning to have your driveway sealed, do that when there is no snow or rain. Just look at some driveway sealcoating Somerset County so that you will know how it would look. If you plan to do that, read the following guidelines.
Somerset is situated on New Jersey and is census designated. It has an area of approximately six square miles. One can see a lot of exciting sites in there. Somerset NJ is one of the most exciting counties you can visit.
The first step is to look for trouble spots. Take note of the cracks, stains, any holes or areas that are crumbling. Look at the ends and edges of your driveway as these are parts which are easily damaged. If there are oil or grease stains, remove them using hot, soapy water and brush. You have to see to it that they are removed. If that was not effective, use a degreaser on it.
You would see some cracks that could be big or small. Before applying any seal, fix them. If it does not get fixed, it can be wider and become longer as time goes by. Many fillers are being sold in stores that you may use to fix it. Do not forget to read and follow the given instructions to have the best result. Before you apply some filler, clean those cracks first. You need to get rid of the dirt, grass or some stones in it.
Patch the holes as well. Brush the area so that it will be clean. Remove any dirt on it. You could then apply asphalt on that. Compact that area to be sure that everything will be filled. Repeat that process until the hole is completely filled. If it sinks, repeat the patching process. Leave that for at least twenty four hours before you seal.
Clean your drive way properly after that. Sweep and use a hose so you could rinse its surfaces. Begin on the highest section going down to its edge. Prior to applying some sealer, verify the weather condition. Everything will dry for approximately 2 to 3 days. You have to see to it that it will be sunny the whole week.
When you apply the sealer, make sure you spread it evenly. There are those which needs a long handled tool with a squeegee on the edge. There are also those that needs a short handled one. Repeat the process until everything is evenly applied. Allow its first coat to dry for six to twelve hours. Apply a second coat after that one. Block the ends of it and wait for at least twenty four hours.
After doing the steps, you would see that it became appealing. Your home looked better with that change. Remember those things if you would be doing this.
If you are planning to have your driveway sealed, do that when there is no snow or rain. Just look at some driveway sealcoating Somerset County so that you will know how it would look. If you plan to do that, read the following guidelines.
Somerset is situated on New Jersey and is census designated. It has an area of approximately six square miles. One can see a lot of exciting sites in there. Somerset NJ is one of the most exciting counties you can visit.
The first step is to look for trouble spots. Take note of the cracks, stains, any holes or areas that are crumbling. Look at the ends and edges of your driveway as these are parts which are easily damaged. If there are oil or grease stains, remove them using hot, soapy water and brush. You have to see to it that they are removed. If that was not effective, use a degreaser on it.
You would see some cracks that could be big or small. Before applying any seal, fix them. If it does not get fixed, it can be wider and become longer as time goes by. Many fillers are being sold in stores that you may use to fix it. Do not forget to read and follow the given instructions to have the best result. Before you apply some filler, clean those cracks first. You need to get rid of the dirt, grass or some stones in it.
Patch the holes as well. Brush the area so that it will be clean. Remove any dirt on it. You could then apply asphalt on that. Compact that area to be sure that everything will be filled. Repeat that process until the hole is completely filled. If it sinks, repeat the patching process. Leave that for at least twenty four hours before you seal.
Clean your drive way properly after that. Sweep and use a hose so you could rinse its surfaces. Begin on the highest section going down to its edge. Prior to applying some sealer, verify the weather condition. Everything will dry for approximately 2 to 3 days. You have to see to it that it will be sunny the whole week.
When you apply the sealer, make sure you spread it evenly. There are those which needs a long handled tool with a squeegee on the edge. There are also those that needs a short handled one. Repeat the process until everything is evenly applied. Allow its first coat to dry for six to twelve hours. Apply a second coat after that one. Block the ends of it and wait for at least twenty four hours.
After doing the steps, you would see that it became appealing. Your home looked better with that change. Remember those things if you would be doing this.
About the Author:
You can visit www.asphaltmaintenancenj.net for more helpful information about Procedures For Doing A Driveway Sealcoating.
No comments:
Post a Comment